KEYCHAIN DRAGONFLY

Send

Once I decided to make a keychain on a mobile Dragonfly. I liked the idea itself and as a result I improved a little and made a second dragonfly.

1. I took a thread with a diameter of 1.5mm green - for a dragonfly body. I rewound 3 strands of 80 cm each, melted the ends on a fire so that they would not fall apart and tied in half a 1 cm diameter ring.

2. Next, we form the frivolite node on the left:

and in the same way on the left.

3. String a bead with a diameter of about 7 mm on the right. I once bought these beads in Montpensier, then I tried to purchase them again, but I could not find them anymore, so the buttons from the sewing store were used in the second dragonfly.
and to the left.

4. After that, we form two knots tatting right and left
5. Accordingly, we knit the two middle threads together

That's what happened, here is such a muzzle turned out.
6. Now I’ll make a wing, for this, we put nine beads flattened with a diameter of about 5 mm on the extreme threads on the right and left.
7. After that, I made a tatting knot in the same way as 2-5 steps, and repeated it 2 times, then formed the second wing in the same way, but from six beads. Here is the little body came out of a dragonfly:

8. Now you can start the formation of the tail. I took the outermost thread on the left and made a tatting knot around the four middle threads, and then exactly the same on the right.