Children's eraser "Sun"

Each girl is a true princess for her near and dear ones; therefore, she should have appropriate jewelry. For example, a charming gum "sun" will be a great addition for braids.
To create it, you should prepare:
- glue gun.
- tape 1 cm wide in light green color.
- tape 5 cm wide in yellow.
- scissors.
- medium sized golden beads.
- tweezers.
- sewing needle with thread.
- rubber.
Sequencing.
From a yellow ribbon, you need to cut out squares, the length of the sides of which should reach 5 cm. 5 pieces of such details will be required.
Now the resulting details should be shaped into a triangle, using addition.
Now you need to thread the needle and make a simple seam along the edge of the triangle. This seam should extend along all sections of the part 2-3 mm from the edge.
After this, the thread cannot be cut, instead, you need to tighten the seam done so that the fabric is gathered in dense folds. Only after this, the seam should be fixed with a few additional stitches and cut the thread. Now you can neatly burn the uneven sections with fire, but it is important to ensure that the seam done does not burn.
Then you can straighten the folds of the petal.
Now from the remaining yellow squares you need to make the same details.
After that, you need to cut 12 pieces of green ribbon 1 cm wide each 7 cm long.
From these segments you need to make petals. To do this, the segment should be placed face up, and not turning, not twisting to fold the edges together on top of each other.
The connected sections must be fused with fire, while soldering the edges. Following these steps you need to make the petals of the remaining segments.
When all the details are ready, then you can proceed to the connection of the flower. To do this, taking 6 lettuce petals, you need to glue them together in a circle, gradually overlaying their edges on a circle, on top of each other. The result should be two flowers.
Now you need to glue them one on top of another in their center.
After that, they can be temporarily put aside and make a flower of yellow petals. They must also be glued into a circle.
Now you need deferred salad circles, because you need to glue the made yellow flower to them.
You need to seal the middle of the resulting inflorescence with beads.
Now you just have to attach the elastic to the base of the flower.
Decoration is ready!